Restoring Your Classic Car with LizardSkin Insulation

Restoring a vintage car is about preserving history while upgrading it with modern comfort and efficiency. LizardSkin Insulation, with its superior thermal and sound-dampening properties, is the perfect choice to enhance your restoration project. Here’s an expanded guide with detailed instructions to help you seamlessly apply LizardSkin products and maximize your car’s performance.

Step 1: Preparation is Key

Before applying LizardSkin, ensure your classic car is prepped for the process:

1. Strip the Interior: Remove seats, carpets, door panels, and other components.
2. Clean Thoroughly: Ensure all surfaces are free of dirt, grease, and rust. Address any rusted areas with a rust inhibitor.
3. Mask Off Non-Target Areas: Use masking tape and plastic sheeting to protect windows, trim, and electrical components.

Step 2: Gather the Right Tools

• SuperPro Application Kit: This specialized sprayer is essential for LizardSkin products to ensure even application. Avoid using brushes or rollers, as these may lead to uneven thickness and curing issues.
• Mixing Paddle and Drill: For thoroughly mixing the product to the correct consistency (like a milkshake).
• Mil Thickness Gauge: To measure the coating thickness during application.

Step 3: Applying LizardSkin Sound Control

1. Prepare the Product:
   • Open the Sound Control bucket and use the mixing paddle to achieve a smooth consistency.
   • Pour the product into the sprayer cup from 12-16 inches above to ensure a clean pour.
2. Adjust the Sprayer:
   • Set the sprayer tip and air pressure (40-60 PSI recommended for Sound Control). Test the spray on cardboard or a trashcan to fine-tune the flow and pattern.
3. Spray the Coating:
   • Hold the sprayer 6-9 inches away from the surface and use a sweeping motion to apply the product evenly.
   • Apply 2-3 passes to achieve a thickness of 20 mils (0.5 mm) per coat.
   • Allow the first coat to dry for at least 60 minutes before applying a second coat.
4. Curing Time: Let the Sound Control dry for 24-36 hours before applying Ceramic Insulation. Ensure the temperature is above 60°F (15°C) for proper drying.

Step 4: Applying LizardSkin Ceramic Insulation

1. Repeat the Preparation Process:
   • Mix the Ceramic Insulation to the consistency of a milkshake and pour it into the sprayer.
   • Adjust the sprayer to 50-70 PSI for Ceramic Insulation and test the spray pattern.
2. Spray the Insulation:
   • Apply the Ceramic Insulation in a similar manner to the Sound Control, covering floors, firewalls, doors, roofs, and wheel wells.
   • Use a 90° tip for hard-to-reach areas like door skins.
3. Layering and Drying:
   • Apply 2-3 passes per coat and measure thickness with the Mil Thickness Gauge. Allow each coat to dry for at least 60 minutes before adding another.

Step 5: Clean Up Thoroughly

After completing the application:

• Immediately clean the sprayer and tools with water to prevent product buildup.
• If cleaning isn’t immediate, submerge the sprayer in a bucket of water for easier cleaning later.

Step 6: Reassemble and Enjoy

Once both coatings have fully cured, reassemble the interior components of your car. With LizardSkin Insulation in place, your restored vehicle will have:

• Superior temperature control for year-round comfort.
• Reduced road noise and engine vibrations for a quieter ride.
• Added protection against rust and corrosion.

By following these detailed steps and leveraging the power of LizardSkin Sound Control and Ceramic Insulation, you can transform your classic car into a more comfortable and durable vehicle while preserving its timeless charm.